When Canon MP268 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MP268. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

Clear the Ink Absorber / Waste Ink Counter

Once the counter is cleared, Canon MP268 should exit the locked state and printing should resume normally.

Maintenance Reminder

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

For best results, avoid rushing button presses—consistent timing matters.

Common Fixes

• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Power-cycle the printer and try again.
• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).

FAQ