Blog

Canon MP230 Ink Absorber Full Reset

How to Reset Ink Absorber on Canon MP230

Canon MP230 Ink Absorber Full Reset

Canon MP230 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MP230 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MP230. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

Perform the Waste Ink Counter Reset

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Common Fixes

  • Power-cycle the printer and try again.
  • Repeat the service mode steps carefully (timing matters).
  • Try a different USB cable/port if using PC software.
  • Use the correct Stop/Reset press count for your series.
  • Close other Canon printer utilities while resetting.

FAQ

Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How long does it take?
Usually a few minutes once the correct steps are followed.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon MP230 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply