When Canon MG6852 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MG6852 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MG6852. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon MG6852

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 6 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

Once the counter is cleared, Canon MG6852 should exit the locked state and printing should resume normally.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Reset tools and instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Frequently Asked Questions