Blog

Canon MG3660 Ink Absorber Full Reset

Canon MG3660 Reset Ink Absorber – Complete Tutorial

Canon MG3660 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MG3660 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MG3660. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

How to Enter Service Mode on Canon MG3660

Some Canon series require entering service mode before the ink absorber counter can be reset.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 6 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

  • Repeat the service mode steps carefully (timing matters).
  • Try a different USB cable/port if using PC software.
  • Use the correct Stop/Reset press count for your series.
  • Power-cycle the printer and try again.
  • Close other Canon printer utilities while resetting.

Frequently Asked Questions

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon MG3660 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply