Blog

Canon MB5140 Ink Absorber Full Reset

MB5140 Waste Ink Counter Reset (Canon Printers)

Canon MB5140 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MB5140 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MB5140. Service mode instructions are shown only when a matching series procedure is known.

Reset the Ink Absorber Counter

Once the counter is cleared, Canon MB5140 should exit the locked state and printing should resume normally.

Important Notes

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Common Fixes

  • Use the correct Stop/Reset press count for your series.
  • Power-cycle the printer and try again.
  • Repeat the service mode steps carefully (timing matters).
  • Try a different USB cable/port if using PC software.
  • Close other Canon printer utilities while resetting.

FAQ

How long does it take?
Usually a few minutes once the correct steps are followed.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon MB5140 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply