Blog

Canon IX6770 Ink Absorber Full Reset

Canon IX6770 Ink Absorber Reset Without Service Center

Canon IX6770 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon IX6770 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon IX6770. Service mode instructions are shown only when a matching series procedure is known.

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Maintenance Reminder

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

  • Try a different USB cable/port if using PC software.
  • Repeat the service mode steps carefully (timing matters).
  • Use the correct Stop/Reset press count for your series.
  • Power-cycle the printer and try again.
  • Close other Canon printer utilities while resetting.

Frequently Asked Questions

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How long does it take?
Usually a few minutes once the correct steps are followed.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon IX6770 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply