Blog

Canon iP4950 Ink Absorber Full Reset

iP4950 Printer Reset – Ink Absorber Counter Explained

Canon iP4950 Ink Absorber Full Reset

Canon iP4950 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon iP4950. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

Finalize the Reset and Restore Printing

Once the counter is cleared, Canon iP4950 should exit the locked state and printing should resume normally.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

FAQ

Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
How long does it take?
Usually a few minutes once the correct steps are followed.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.

Guide prepared for Canon iP4950 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply