Blog

Canon iP4840 Ink Absorber Full Reset

Reset Canon iP4840 Waste Ink Counter Easily

Canon iP4840 Ink Absorber Full Reset

If your Canon iP4840 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon iP4840. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

Reset the Ink Absorber Counter

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Warnings

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

  • Repeat the service mode steps carefully (timing matters).
  • Power-cycle the printer and try again.
  • Try a different USB cable/port if using PC software.
  • Close other Canon printer utilities while resetting.
  • Use the correct Stop/Reset press count for your series.

Frequently Asked Questions

How long does it take?
Usually a few minutes once the correct steps are followed.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon iP4840 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply