Blog

Canon iP4760 Ink Absorber Full Reset

iP4760 Waste Ink Counter Reset (Canon Printers)

Canon iP4760 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon iP4760 is common after many cleaning cycles. In most cases, a counter reset restores printing.

During head cleaning, surplus ink is routed to internal absorber pads. Canon iP4760 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon iP4760. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

  • Service / maintenance warning on the screen or driver
  • Printer refuses to print even with ink available
  • Blinking lights and queued jobs fail
  • Error reappears after restart

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon iP4760 should exit the locked state and printing should resume normally.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

FAQ

How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How long does it take?
Usually a few minutes once the correct steps are followed.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon iP4760 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply