Canon iP3680 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon iP3680. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Maintenance Reminder

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

If your model does not show a service mode section, it means no matching procedure was found for its series.

Troubleshooting

• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.

Frequently Asked Questions