Blog

Canon iP3600 Ink Absorber Full Reset

Fix Ink Absorber Full Error on Canon iP3600

Canon iP3600 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon iP3600 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon iP3600. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Frequently Asked Questions

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
How long does it take?
Usually a few minutes once the correct steps are followed.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon iP3600 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply