Blog

Canon iP2702 Ink Absorber Full Reset

Fix Ink Absorber Full Error on Canon iP2702

Canon iP2702 Ink Absorber Full Reset

Canon iP2702 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon iP2702 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon iP2702. Service mode instructions are shown only when a matching series procedure is known.

Reset the Ink Absorber Counter

Once the counter is cleared, Canon iP2702 should exit the locked state and printing should resume normally.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Common Fixes

  • Power-cycle the printer and try again.
  • Try a different USB cable/port if using PC software.
  • Use the correct Stop/Reset press count for your series.
  • Close other Canon printer utilities while resetting.
  • Repeat the service mode steps carefully (timing matters).

FAQ

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
How long does it take?
Usually a few minutes once the correct steps are followed.

Guide prepared for Canon iP2702 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply