When Canon iP2700 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon iP2700. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

Reset the Ink Absorber Counter

Once the counter is cleared, Canon iP2700 should exit the locked state and printing should resume normally.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Common Fixes

• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Power-cycle the printer and try again.

FAQ