When Canon iP2600 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon iP2600. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

Finalize the Reset and Restore Printing

Once the counter is cleared, Canon iP2600 should exit the locked state and printing should resume normally.

Maintenance Reminder

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.

FAQ