If your Canon G5000 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon G5000. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon G5000

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Maintenance Reminder

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Reset tools and instructions

For best results, avoid rushing button presses—consistent timing matters.

FAQ