Blog

Canon G2111 Ink Absorber Full Reset

Canon G2111 Service Required Error – Reset Solution

Canon G2111 Ink Absorber Full Reset

If your Canon G2111 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon G2111. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

  • Service / maintenance warning on the screen or driver
  • Printer refuses to print even with ink available
  • Blinking lights and queued jobs fail
  • Error reappears after restart

How to Enter Service Mode on Canon G2111

If your Canon G2111 supports service mode reset, follow the steps below before performing the counter reset.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 5 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon G2111 should exit the locked state and printing should resume normally.

Important Notes

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

  • Close other Canon printer utilities while resetting.
  • Power-cycle the printer and try again.
  • Repeat the service mode steps carefully (timing matters).
  • Try a different USB cable/port if using PC software.
  • Use the correct Stop/Reset press count for your series.

Frequently Asked Questions

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
How long does it take?
Usually a few minutes once the correct steps are followed.

Guide prepared for Canon G2111 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply