Блог

Epson XP-30 Reset Waste Ink Counter

  • Автор на публикацията:
  • Публикувайте коментари:0 коментара
Epson XP-30 Ink Pad Counter Reset Guide

Epson XP-30 Waste Ink Counter Reset

When the Epson XP-30 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson XP-30 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson XP-30 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson XP-30 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Reset Epson XP-30 Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson XP-30 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-30.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-30.
Buy Wic Reset Key

Most Epson XP-30 waste counter resets finish in ~1–2 minutes.

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson XP-30 – Waste Ink Counter Reset using Wic Reset Connect.

Вашият коментар