When the Epson XP-206 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson XP-206 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why Does the Epson XP-206 Show ‘Service Required’?

Most Epson XP-206 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson XP-206 Waste Ink Counter in 3 Steps

1. Step 1: Connect Epson XP-206 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-206.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-206.

Most Epson XP-206 waste counter resets finish in ~1–2 minutes.

System Requirements

• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• Stable Internet connection during reset

Common Fixes

• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.