Блог

Epson WorkForce 600 Reset Waste Ink Counter

  • Автор на публикацията:
  • Публикувайте коментари:0 коментара
Fix Epson WorkForce 600 Service Required – Waste Counter Reset

Epson WorkForce 600 Waste Ink Counter Reset

The Epson WorkForce 600 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson WorkForce 600 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson WorkForce 600 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson WorkForce 600 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Step-by-Step: Epson WorkForce 600 Waste Counter Reset

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson WorkForce 600 directly. Keep Internet enabled for validation.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson WorkForce 600 appears in the device list.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson WorkForce 600.
Buy Wic Reset Key

Most Epson WorkForce 600 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Restart printer and PC, then try again.
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).
  • Temporarily disable VPN/proxy if validation fails.
  • Try another USB cable (some cables are charge-only).

Frequently Asked Questions

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson WorkForce 600 – Waste Ink Counter Reset using Wic Reset Connect.

Вашият коментар