Блог

Epson WorkForce 60 Reset Waste Ink Counter

  • Автор на публикацията:
  • Публикувайте коментари:0 коментара
Epson WorkForce 60 Ink Pad Counter Reset Guide

Epson WorkForce 60 Waste Ink Counter Reset

When the Epson WorkForce 60 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WorkForce 60 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson WorkForce 60 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson WorkForce 60 waste counter reset in minutes.

How the Error Appears

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Three Steps to Restore Epson WorkForce 60 Printing

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson WorkForce 60 directly. Keep Internet enabled for validation.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson WorkForce 60 appears in the device list.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson WorkForce 60 to finalize.
Buy Wic Reset Key

Most Epson WorkForce 60 waste counter resets finish in ~1–2 minutes.

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson WorkForce 60 – Waste Ink Counter Reset using Wic Reset Connect.

Вашият коментар