When the Epson TX106 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX106 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson TX106 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson TX106 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson TX106 Waste Ink Counter in 3 Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX106 via USB (Wi-Fi reset is not supported).
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX106 appears in the device list.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX106.

Most Epson TX106 waste counter resets finish in ~1–2 minutes.

Frequently Asked Questions