Блог

Epson TX102 Reset Waste Ink Counter

  • Автор на публикацията:
  • Публикувайте коментари:0 коментара
Fix Epson TX102 Service Required – Waste Counter Reset

Epson TX102 Waste Ink Counter Reset

If your Epson TX102 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson TX102 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson TX102 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson TX102 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Three Steps to Restore Epson TX102 Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX102 via USB (Wi-Fi reset is not supported).
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson TX102.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX102.
Buy Wic Reset Key

Most Epson TX102 waste counter resets finish in ~1–2 minutes.

System Requirements

  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key

FAQ

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson TX102 – Waste Ink Counter Reset using Wic Reset Connect.

Вашият коментар