When the Epson T13 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson T13 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson T13 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson T13 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Reset Epson T13 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson T13 directly. Keep Internet enabled for validation.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson T13.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson T13.

Most Epson T13 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Common Fixes

• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).

FAQ