When the Epson C79 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson C79 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson C79 Show ‘Service Required’?

Most Epson C79 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson C79 Ink Pad Counter Reset – Quick Steps

1. Step 1: Connect Epson C79 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson C79 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson C79.

Most Epson C79 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)

Troubleshooting

• Temporarily disable VPN/proxy if validation fails.
• Restart printer and PC, then try again.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.

FAQ