When the Epson XP-305 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson XP-305 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson XP-305 Stops Printing (Waste Counter Limit)

Most Epson XP-305 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson XP-305 Printing

1. Step 1: Connect Epson XP-305 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson XP-305 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-305.

Most Epson XP-305 waste counter resets finish in ~1–2 minutes.

System Requirements

• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.

FAQ