When the Epson Artisan 810 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson Artisan 810 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Understanding the Epson Artisan 810 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson Artisan 810 waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson Artisan 810 Printing

1. Step 1: Prepare a Windows PC + USB cable and connect Epson Artisan 810 directly. Keep Internet enabled for validation.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson Artisan 810.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson Artisan 810.

Most Epson Artisan 810 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC

Troubleshooting

• Run the app as Administrator.
• Temporarily disable VPN/proxy if validation fails.
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).

FAQ