The “Ink Absorber Full” / service required message on Canon TS6080 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS6080. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon TS6080

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Maintenance Reminder

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Download & get started

For best results, avoid rushing button presses—consistent timing matters.

Common Fixes

• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.
• Power-cycle the printer and try again.