Blog

Canon TS3520 Ink Absorber Full Reset

How to Reset Ink Absorber on Canon TS3520

Canon TS3520 Ink Absorber Full Reset

When Canon TS3520 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon TS3520 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon TS3520. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

How to Enter Service Mode on Canon TS3520

To access maintenance functions, Canon TS3520 may need to be placed in service mode first.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 5 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon TS3520 should exit the locked state and printing should resume normally.

Important Notes

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Troubleshooting

  • Repeat the service mode steps carefully (timing matters).
  • Close other Canon printer utilities while resetting.
  • Try a different USB cable/port if using PC software.
  • Use the correct Stop/Reset press count for your series.
  • Power-cycle the printer and try again.

Frequently Asked Questions

Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.

Guide prepared for Canon TS3520 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply