Blog

Canon MX454 Ink Absorber Full Reset

Fix Ink Absorber Full Error on Canon MX454

Canon MX454 Ink Absorber Full Reset

When Canon MX454 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MX454 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MX454. Service mode instructions are shown only when a matching series procedure is known.

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon MX454 should exit the locked state and printing should resume normally.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Common Fixes

  • Use the correct Stop/Reset press count for your series.
  • Power-cycle the printer and try again.
  • Close other Canon printer utilities while resetting.
  • Try a different USB cable/port if using PC software.
  • Repeat the service mode steps carefully (timing matters).

Frequently Asked Questions

Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.

Guide prepared for Canon MX454 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply