When Canon MB5350 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MB5350. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.
• Use the correct Stop/Reset press count for your series.

Frequently Asked Questions