Blog

Canon iP4870 Ink Absorber Full Reset

Canon iP4870 Ink Absorber Reset Without Service Center

Canon iP4870 Ink Absorber Full Reset

When Canon iP4870 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon iP4870 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon iP4870. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

Clear the Ink Absorber / Waste Ink Counter

Once the counter is cleared, Canon iP4870 should exit the locked state and printing should resume normally.

Maintenance Reminder

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Frequently Asked Questions

How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon iP4870 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply