Blog

Canon G5010 Ink Absorber Full Reset

G5010 Printer Reset – Ink Absorber Counter Explained

Canon G5010 Ink Absorber Full Reset

Canon G5010 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon G5010. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

How to Enter Service Mode on Canon G5010

If your Canon G5010 supports service mode reset, follow the steps below before performing the counter reset.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 5 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

  • Repeat the service mode steps carefully (timing matters).
  • Use the correct Stop/Reset press count for your series.
  • Power-cycle the printer and try again.
  • Close other Canon printer utilities while resetting.
  • Try a different USB cable/port if using PC software.

FAQ

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
How long does it take?
Usually a few minutes once the correct steps are followed.

Guide prepared for Canon G5010 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply