Blog

Epson L3110 Reset Waste Ink Counter

Reset Epson L3110 Waste Ink Counter in Minutes

Epson L3110 Waste Ink Counter Reset

When the Epson L3110 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson L3110 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson L3110 Show ‘Service Required’?

Most Epson L3110 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson L3110 Waste Counter Reset

  1. Step 1: Connect Epson L3110 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson L3110 is detected.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L3110.
Buy Wic Reset Key

Most Epson L3110 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

  • Temporarily disable VPN/proxy if validation fails.
  • Try another USB cable (some cables are charge-only).
  • Restart printer and PC, then try again.
  • Close Epson Status Monitor or other printer utilities.
  • Run the app as Administrator.

Frequently Asked Questions

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson L3110 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply