The Epson XP-443 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-443 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-443 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-443 waste counter reset in minutes.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson XP-443 Printing

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-443 via USB (Wi-Fi reset is not supported).
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-443 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-443.

Most Epson XP-443 waste counter resets finish in ~1–2 minutes.

Troubleshooting

• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.

Frequently Asked Questions