Блог

Epson TX410 Reset Waste Ink Counter

Epson TX410 Ink Pad Counter Reset Guide

Epson TX410 Waste Ink Counter Reset

If your Epson TX410 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX410 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson TX410 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson TX410 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson TX410 Waste Counter Reset

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX410 via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX410 appears in the device list.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX410.
Buy Wic Reset Key

Most Epson TX410 waste counter resets finish in ~1–2 minutes.

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson TX410 – Waste Ink Counter Reset using Wic Reset Connect.

Залишити відповідь