Блог

Epson TX203 Reset Waste Ink Counter

Epson TX203 Ink Pad Counter Reset Guide

Epson TX203 Waste Ink Counter Reset

When the Epson TX203 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX203 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson TX203 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson TX203 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson TX203 Waste Counter Reset

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX203 via USB (Wi-Fi reset is not supported).
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX203 is detected.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX203.
Buy Wic Reset Key

Most Epson TX203 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC

Frequently Asked Questions

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson TX203 – Waste Ink Counter Reset using Wic Reset Connect.

Залишити відповідь