The Epson PX810FW is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson PX810FW uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson PX810FW Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson PX810FW waste counter reset in minutes.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson PX810FW Ink Pad Counter Reset – Quick Steps

1. Step 1: Connect Epson PX810FW to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson PX810FW is detected.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson PX810FW to finalize.

Most Epson PX810FW waste counter resets finish in ~1–2 minutes.

System Requirements

• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key

Common Fixes

• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).

FAQ