Блог

Epson ME-510 Reset Waste Ink Counter

Epson ME-510 Ink Pad Counter Reset Guide

Epson ME-510 Waste Ink Counter Reset

When the Epson ME-510 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ME-510 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson ME-510 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson ME-510 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Three Steps to Restore Epson ME-510 Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson ME-510 via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson ME-510 appears in the device list.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ME-510.
Buy Wic Reset Key

Most Epson ME-510 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key

Frequently Asked Questions

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson ME-510 – Waste Ink Counter Reset using Wic Reset Connect.

Залишити відповідь