When the Epson L201 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson L201 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson L201 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L201 waste counter reset in minutes.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson L201 Ink Pad Counter Reset – Quick Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson L201 directly. Keep Internet enabled for validation.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L201.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L201.

Most Epson L201 waste counter resets finish in ~1–2 minutes.

What You Need

• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset

Troubleshooting

• Run the app as Administrator.
• Restart printer and PC, then try again.
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).

FAQ