When the Epson ET-M1109 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-M1109 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ET-M1109 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-M1109 waste counter reset in minutes.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Three Steps to Restore Epson ET-M1109 Printing

1. Step 1: Connect Epson ET-M1109 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-M1109 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-M1109.

Most Epson ET-M1109 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key

Common Fixes

• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.