When the Epson ET-2760 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson ET-2760 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Understanding the Epson ET-2760 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-2760 waste counter reset in minutes.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson ET-2760 Printing

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-2760 via USB (Wi-Fi reset is not supported).
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson ET-2760 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-2760.

Most Epson ET-2760 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• Stable Internet connection during reset

Troubleshooting

• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions