Blog

Epson TX219 Reset Waste Ink Counter

Epson TX219 Waste Ink Counter Reset

Epson TX219 Waste Ink Counter Reset

When the Epson TX219 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX219 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson TX219 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson TX219 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Reset Epson TX219 Waste Ink Counter in 3 Steps

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX219 via USB (Wi-Fi reset is not supported).
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson TX219.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX219.
Buy Wic Reset Key

Most Epson TX219 waste counter resets finish in ~1–2 minutes.

What You Need

  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson TX219 – Waste Ink Counter Reset using Wic Reset Connect.

Lasă un răspuns