Blog

Epson L4260 Reset Waste Ink Counter

Epson L4260 Ink Pad Counter Reset Guide

Epson L4260 Waste Ink Counter Reset

When the Epson L4260 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L4260 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson L4260 Ink Pad Counter Warning?

Most Epson L4260 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Reset Epson L4260 Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson L4260 directly. Keep Internet enabled for validation.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson L4260 appears in the device list.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson L4260 to finalize.
Buy Wic Reset Key

Most Epson L4260 waste counter resets finish in ~1–2 minutes.

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson L4260 – Waste Ink Counter Reset using Wic Reset Connect.

Lasă un răspuns