When the Epson ET-2402 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson ET-2402 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

What Causes the Epson ET-2402 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-2402 waste counter reset in minutes.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson ET-2402 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson ET-2402 directly. Keep Internet enabled for validation.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2402 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-2402.

Most Epson ET-2402 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)

Common Fixes

• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).

FAQ