When the Epson WF-2510 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson WF-2510 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson WF-2510 Stops Printing (Waste Counter Limit)

Most Epson WF-2510 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Step-by-Step: Epson WF-2510 Waste Counter Reset

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson WF-2510 via USB (Wi-Fi reset is not supported).
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson WF-2510 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WF-2510.

Most Epson WF-2510 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Common Fixes

• Temporarily disable VPN/proxy if validation fails.
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.

Frequently Asked Questions