Blog

Epson RX690 Reset Waste Ink Counter

  • Autore dell'articolo:
  • Commenti dell'articolo:0 commenti
Epson RX690 Waste Ink Counter Reset

Epson RX690 Waste Ink Counter Reset

When the Epson RX690 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson RX690 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson RX690 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson RX690 waste counter reset in minutes.

Reset Epson RX690 Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson RX690 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson RX690.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson RX690 to finalize.
Buy Wic Reset Key

Most Epson RX690 waste counter resets finish in ~1–2 minutes.

What You Need

  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)

Troubleshooting

  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson RX690 – Waste Ink Counter Reset using Wic Reset Connect.

Lascia un commento