Blog

Epson L222 Reset Waste Ink Counter

  • Autore dell'articolo:
  • Commenti dell'articolo:0 commenti
Epson L222 Waste Ink Counter Reset

Epson L222 Waste Ink Counter Reset

When the Epson L222 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson L222 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson L222 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L222 waste counter reset in minutes.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Reset Epson L222 Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson L222 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L222.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L222.
Buy Wic Reset Key

Most Epson L222 waste counter resets finish in ~1–2 minutes.

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson L222 – Waste Ink Counter Reset using Wic Reset Connect.

Lascia un commento