Blog

Epson EW-M571T Reset Waste Ink Counter

  • Autore dell'articolo:
  • Commenti dell'articolo:0 commenti
Epson EW-M571T Ink Pad Counter Reset Guide

Epson EW-M571T Waste Ink Counter Reset

If your Epson EW-M571T suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson EW-M571T tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson EW-M571T Waste Ink Counter

Most Epson EW-M571T waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Reset Epson EW-M571T Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson EW-M571T directly. Keep Internet enabled for validation.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson EW-M571T is detected.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson EW-M571T.
Buy Wic Reset Key

Most Epson EW-M571T waste counter resets finish in ~1–2 minutes.

System Requirements

  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key

Troubleshooting

  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).
  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson EW-M571T – Waste Ink Counter Reset using Wic Reset Connect.

Lascia un commento