Blog

Epson WorkForce 620 Reset Waste Ink Counter

  • Autore dell'articolo:
  • Commenti dell'articolo:0 commenti
Epson WorkForce 620 Ink Pad Counter Reset Guide

Epson WorkForce 620 Waste Ink Counter Reset

If your Epson WorkForce 620 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson WorkForce 620 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson WorkForce 620 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson WorkForce 620 waste counter reset in minutes.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson WorkForce 620 Waste Counter Reset

  1. Step 1: Connect Epson WorkForce 620 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson WorkForce 620.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson WorkForce 620.
Buy Wic Reset Key

Most Epson WorkForce 620 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson WorkForce 620 – Waste Ink Counter Reset using Wic Reset Connect.

Lascia un commento