When the Epson WF-7521 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WF-7521 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson WF-7521 Ink Pad Counter Warning?

Most Epson WF-7521 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson WF-7521 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson WF-7521 directly. Keep Internet enabled for validation.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson WF-7521 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WF-7521.

Most Epson WF-7521 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)

Common Fixes

• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.
• Restart printer and PC, then try again.

Frequently Asked Questions